|
The sdvizhnaja panel of a roof
Installation components сдвижной roof panels
Assemblage components сдвижной roof panels
Replacement and drive adjustment сдвижной roof panels
|
|
- Remove a plafond of illumination of salon (the Onboard electric equipment see the Head).
- Remove with кривошипного a drive the handle and a cover.
Handle removal кривошипного a drive
- Turn out screws of fastening and remove кривошипный a drive from the drive case.
Fastening screws кривошипного a drive
- Put кривошипный a drive in installation position. Establish into place the drive handle, the pin specifies in a direction of movement of the car.
Components кривошипного a drive
- Turn the handle clockwise against the stop.
- Turn the handle on three complete revolutions in the opposite direction. If full turn кривошипного a drive does not occur, replace a drive.
- Fix the handle and establish a fixture plafond.
|
|
Adjustment of cables of a drive сдвижной roof panels (model Corsa)
|
|
- Remove a glass cover, a drainage system and кривошипный a drive.
- Displace directing side scenes with directing a cable against the stop forward.
- Displace a connecting finger (1) directing a cable back so that adjusting labels (2) directing side scenes have coincided.
Drive components сдвижной panels
- Establish a clip (3) directing side scenes so that ползун a clip passed by a back edge of a groove of the tyre with displacement 0.2 0.5 mm.
|
|
|