Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
- Brake system
The general information
System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
Prorolling of brake system
Check of a condition and replacement of brake lines and hoses
Replacement колодок disk brake mechanisms of forward wheels
Removal and installation of brake boots
Replacement of brake overlays of drum-type brakes
Condition check, removal and installation of a brake disk
Removal, check of a condition and installation of a brake drum
Removal, regenerative repair and installation of supports of disk brake mechanisms of forward wheels
Removal, service and installation of wheel cylinders of drum-type brake mechanisms of back wheels
Check of serviceability of functioning and tightness of the vacuum amplifier of brakes
Replacement and check of the vacuum pump of the servo-driver of the brake amplifier (diesel models)
Adjustment of a drive of a lay brake
Removal and installation of cables of a drive of a lay brake
Replacement of the gauge-switch of stoplights
The pressure valve-regulator in hydraulic contours of brake mechanisms of back wheels
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement of brake overlays of drum-type brakes
|
|
- Remove brake boots. Necessarily brake overlays of both wheels are replaced.
- Drill rivets of a brake overlay and beat out them.
Drilling of rivets of a brake overlay
- Brake overlays of two thickness are delivered:
-
Overlays of a normal thickness (5 mm) can be established at once after клепки and are not applied to the pierced brake drums.
-
Overlays of the raised thickness (5.6 mm) are established in the event that the brake drum was preliminary pierced. Brake overlays after клепки should get used by grinding car in radius on 0.2 mm of less radius of a processed brake drum.
- Carefully clear interfaced surfaces of brake boots.
|
|
Do not put glue between brake overlays and a drum. |
- Приклепайте brake overlays to boots.
|
|
Insert rivets outside through a brake boot and расклепайте them from within. Watch that the rivet head was pure, equal and in regular intervals laid down on a brake boot. |
- At клепке a new overlay begin with the middle.
|
|
Watch that overlays in regular intervals adjoined to boots and anywhere had no backlash. |
- Establish brake boots.
|
|
|
|