Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
- Brake system
The general information
System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
Prorolling of brake system
Check of a condition and replacement of brake lines and hoses
Replacement колодок disk brake mechanisms of forward wheels
Removal and installation of brake boots
Replacement of brake overlays of drum-type brakes
Condition check, removal and installation of a brake disk
Removal, check of a condition and installation of a brake drum
Removal, regenerative repair and installation of supports of disk brake mechanisms of forward wheels
Removal, service and installation of wheel cylinders of drum-type brake mechanisms of back wheels
Check of serviceability of functioning and tightness of the vacuum amplifier of brakes
Replacement and check of the vacuum pump of the servo-driver of the brake amplifier (diesel models)
Adjustment of a drive of a lay brake
Removal and installation of cables of a drive of a lay brake
Replacement of the gauge-switch of stoplights
The pressure valve-regulator in hydraulic contours of brake mechanisms of back wheels
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of serviceability of functioning and tightness of the vacuum amplifier of brakes Check of serviceability of functioning
|
|
- Without starting the engine, some times squeeze out a pedal of a foot brake. Make sure of absence of changes in size of a reserve course of a pedal (distance between a pedal and a floor).
- Keeping a pedal squeezed out, start the engine. If right after start the pedal slightly "fails", hence, the vacuum amplifier of brakes works regularly.
|
|
Tightness check
|
|
- Start the engine on pair minutes, then muffle. Some times slowly squeeze out a pedal of a foot brake. If at first the course of a pedal with each squeezing is gradually reduced, however, through three-four rolling is stabilised, tightness of assemblage of the vacuum amplifier is not broken.
- Squeeze out a pedal of a foot brake at the working engine. Keeping a pedal pressed, muffle the engine. If later 30 seconds of keeping of a pedal pressed its reserve course does not change, hence, tightness of assemblage of the vacuum amplifier is not broken, - in case of need check up serviceability of the return valve of the servo-driver of the amplifier (the valve purge should be possible only in one party). On diesel models check up serviceability of functioning of the vacuum pump (the Section Replacement and check of the vacuum pump of the servo-driver of the brake amplifier (diesel models) see). Any infringements it is not observed, replace the block of the servo-driver of the amplifier of brakes, - the block is not subject to regenerative repair and in default should be replaced in gathering.
|
|
|
|