Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation



Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
- Engines
   The general information
   Check компрессионного pressure in cylinders and parametres of impellent oil
   Diagnostics of a condition of the engine with vacuum gauge application
   - Procedures of repair of petrol engines SOHC without their extraction from the car
      Removal and cover installation газораспределительного the mechanism
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of a cover of drive ГРМ
      Removal and installation of a belt of drive ГРМ
      Removal and installation of cogwheels of drive ГРМ
      Replacement of an epiploon of a camshaft
      Removal, check of a condition and installation of a camshaft from the case газораспределительного the mechanism
      Removal, check of a condition and installation of valves
      Removal and installation of a head of cylinders
      Removal and pallet installation картера
      Removal, service and installation of the oil pump
      Removal, check of a condition and installation of a flywheel/privodnogo of a disk
      Replacement of epiploons of a cranked shaft
   + Procedures of repair of petrol engines DOHC without their extraction from the car
   + Procedures of repair of diesel engines without their extraction from the car
   + The general and engine major repairs
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of a cover of drive ГРМ

Removal

The top section

 PERFORMANCE ORDER

  1. Remove an air cleaner (see the Head of the Power supply system, release and decrease in toxicity of the fulfilled gases).
  2. Turn out fixing screws and remove the top section of a cover газораспределительного a belt.

The top and bottom sections of a cover of drive ГРМ

The bottom section

 PERFORMANCE ORDER

  1. Remove the top section of a cover.
  2. Remove a pulley of a cranked shaft (see Has undressed Removal and installation of a pulley of a cranked shaft).
  3. Turn out fixing bolts and remove from the engine the bottom section of a cover (address to an illustration).

Back cover

 PERFORMANCE ORDER

  1. Remove газораспределительный a belt, it натяжитель and cogwheels of drive ГРМ (Sections Removal and installation of a belt of drive ГРМ and Removal and installation of cogwheels of drive ГРМ see).
  2. Liberate from clamps on a cover electroconducting of the gauge of position of a cranked shaft (CKP), - try to remember a route of its lining.
  3. Turn out fixing bolts and remove a back cover from the engine.

Screws of fastening of a back cover of drive ГРМ

Installation

Installation is made in an order, the return to an order of dismantle of components. Track correctness of a lining and reliability of fixing of electroconducting of gauge CKP. At installation of a pulley of a cranked shaft do not forget to replace a bolt of its fastening. All fixture tighten with demanded effort.