- Mark with a sticky tape position of a brush of a screen wiper on glass for the subsequent installation.
- Cast away a protective cover of the lever of a back screen wiper and give a nut. Remove the lever and the remote plug.
Nuts of fastening of the lever of a back screen wiper
- Give a nut (marksman) on a screen wiper axis. On model Tigra the nut is closed by a cover - remove it.
- Turn out screws of fastening of internal facing of a door of a back and remove it (the Body see the Head).
- Separate a socket of the e/motor of a screen wiper.
- Turn out screws of fastening of the e/motor on the holder and disconnect a weight wire.
|
|
Screws of fastening of the e/motor of a back screen wiper and weight wire (models Corsa and Combo) |
|
|
Screws of fastening of the e/motor of a back screen wiper and weight wire (model Tigra) |
- If the new e/motor is established, establish it in parking position. For this purpose connect a socket and start the e/motor. Then stop its switch of a screen wiper and allow to it to come in final position.
- Establish all acting in film components.
|