Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation



Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   The general information and safety measures
   Search of causes of failures of an electric equipment
   Safety locks - the general information
   The relay - the general information and check of serviceability of functioning
   Removal and installation of the e/motor of the uniform lock
   Adjustment of range of light
   Removal and installation of the switch and the e/motor of adjustment of range of light (Model Corsa and Combo)
   Removal and installation of the switch of heating of a seat
   Removal and horn installation
   The antijoy ride device and the alarm system
   Replacement of lamps накаливания in headlights
   Replacements of lamps накаливания devices of external illumination
   Replacement of lamps накаливания in headlights, parking fires and forward indexes of turn of model Tigra
   Replacement of lamps накаливания illumination of salon, a luggage space and a ware box
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of the back combined lantern
   Removal and installation of an antifog headlight
   Removal and installation of a combination of devices
   Removal and installation of measuring devices and indexes
   Removal and installation of control lamps and the printed-circuit board of a combination of devices
   Replacement of a lamp of illumination of the panel of the block of management with heating
   Removal and installation подрулевого the switch
   Removal and installation of switches of a back foggy headlight (antifog headlight) and heating of seats
   Removal and installation of the switch of external and internal illumination
   Removal and installation of the switch of the alarm system
   Removal and installation of the cylinder of the lock of ignition and its contact element
   Radio receiver installation
   Removal and installation динамиков
   Aerial installation
   Removal and installation of a screen wiper of a windscreen
   Removal and installation of the e/motor of a forward screen wiper
   Removal and installation of the e/motor of a back screen wiper
   Removal and tank and pump installation стеклоомывателя
   Check К/Л of low level of a brake liquid
   Check of serviceability of functioning and regenerative repair of a heater of back glass
   + Schemes of electric connections - the general information



Removal and installation of a combination of devices

On models since 09.1996 вып. The electronic speedometer with the gauge of speed is established. The speedometer shaft on these models is absent.


 PERFORMANCE ORDER

  1. Turn out screws of fastening and remove overlays of a steering column. To turn out screws (2) on a face sheet, turn a steering wheel on 90 hailstones. The combination of devices can be taken out without removing a steering wheel.

Screws of fastening of overlays of a steering column

  1. Remove a rubber cover of the lock of ignition.
  2. Turn out screws of fastening and remove the protective panel of a combination of devices (address to an accompanying illustration).
  3. Disconnect a shaft of a speedometer from РКПП Remove a rubber sealant of a shaft of a speedometer from a partition of an impellent compartment.

Fastening of a shaft of a speedometer to РКПП

  1. Turn out screws of fastening of a combination of devices (the marksman below). Cautiously take away a small screw-driver lock скобы (an arrow above) and take out a combination of devices from the panel of devices Thus watch that the speedometer shaft remained mobile. If necessary ask the assistant to advance a shaft in salon.

Removal of a combination of devices

  1. On models till 08.1996 of release disconnect a speedometer shaft behind from a combination of devices. For this purpose press a finger a spring stopper and separate a shaft from a speedometer.

Detachment of a shaft of a speedometer from a combination of devices

  1. Separate an electroconducting socket.
  2. Installation is made upside-down.