|
Removal and installation of the cylinder of the lock of ignition and its contact element The cylinder of the lock of ignition
|
|
- The steering wheel lock should not be locked.
- Remove overlays of a steering column.
- Insert the ignition key and turn it in position II.
|
|
On models since 05.1993 вып. Establish a key in position I. Locks of ignition of old and new execution are interchangeable. |
- Press a small screw-driver or a wire a lock spring. Take out the cylinder of the lock with the ignition key.
Pressing of a lock spring
- For installation insert the lock cylinder in position II (on models from 05.1993 вып. - in position I), having fixed it.
|
|
|
|
If on the car till 05.1993 вып. It is established the cylinder of the lock of new execution, turn a screw-driver a contact element before cylinder installation in position I. |
Contact element (models till 08.1994 вып.)
|
|
- Remove overlays of a steering column.
- Separate a socket of a contact element and turn out two screws located opposite each other.
Screws of a contact element
- Remove a contact element.
- Installation is made upside-down.
|
|
|