Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation



Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   The general information and safety measures
   Search of causes of failures of an electric equipment
   Safety locks - the general information
   The relay - the general information and check of serviceability of functioning
   Removal and installation of the e/motor of the uniform lock
   Adjustment of range of light
   Removal and installation of the switch and the e/motor of adjustment of range of light (Model Corsa and Combo)
   Removal and installation of the switch of heating of a seat
   Removal and horn installation
   The antijoy ride device and the alarm system
   Replacement of lamps накаливания in headlights
   Replacements of lamps накаливания devices of external illumination
   Replacement of lamps накаливания in headlights, parking fires and forward indexes of turn of model Tigra
   Replacement of lamps накаливания illumination of salon, a luggage space and a ware box
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of the back combined lantern
   Removal and installation of an antifog headlight
   Removal and installation of a combination of devices
   Removal and installation of measuring devices and indexes
   Removal and installation of control lamps and the printed-circuit board of a combination of devices
   Replacement of a lamp of illumination of the panel of the block of management with heating
   Removal and installation подрулевого the switch
   Removal and installation of switches of a back foggy headlight (antifog headlight) and heating of seats
   Removal and installation of the switch of external and internal illumination
   Removal and installation of the switch of the alarm system
   Removal and installation of the cylinder of the lock of ignition and its contact element
   Radio receiver installation
   Removal and installation динамиков
   Aerial installation
   Removal and installation of a screen wiper of a windscreen
   Removal and installation of the e/motor of a forward screen wiper
   Removal and installation of the e/motor of a back screen wiper
   Removal and tank and pump installation стеклоомывателя
   Check К/Л of low level of a brake liquid
   Check of serviceability of functioning and regenerative repair of a heater of back glass
   + Schemes of electric connections - the general information


Radio receiver installation

 PERFORMANCE ORDER

  1. Before installation check up radio receiver work.
  2. Disconnect a negative wire from the battery.
  3. Remove заглушку radio receiver mines.
  4. Attach a radio receiver.

Company Opel delivers the special complete set of wires for installation of a radio receiver which contains weight wires, a positive wire and conducting динамиков with sockets. If the special complete set of electroconducting is not applied, watch that nearby there were no not isolated wires. Short circuit can lead to cable ignition.

  1. Attach to a radio reception socket адаптерный a cable or radio receiver sockets.
  2. Fix a weight wire on the holder of a steering column.

Fastening of a wire of weight

  1. In the absence of the complete set of wires of a radio receiver remove the block of safety locks under the left part of the panel of devices, connect a wire of a current of long loading (the plug 30) to a safety lock exit № 1, a current wire at the switched off ignition (the plug 15) - to a safety lock exit № 17, a wire of illumination of a radio receiver (the plug 58) - to a safety lock exit № 23 Fix a wire of weight from the holder of a steering column on a radio receiver.

Screws of a contact element

  1. Lay a wire from a radio receiver to the aerial or its amplifier and connect it.
  2. Establish a framework of the holder of a radio receiver.

Fastening of a framework of the holder of a radio receiver

  1. Push a radio receiver in the holder.
  2. Connect a negative wire to the battery.

Attach a negative wire толькопри the switched off ignition not to damage ECM.

  1. Establish hours.
  2. Enter a radio receiver code.
  3. Provide noise immunity of a radio receiver according to the instruction on its installation.