Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation



Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of steering draught
      Removal and installation of a tip of steering draught
      Removal and installation of the tank of liquid ГУР
      Removal of air of hydraulic path ГУР
      Removal and pump GUR installation
      Corners of installation of wheels
+ Body
+ Onboard electric equipment
премьеры кино, ознакомиться детальнее.



Removal and pump GUR installation

Removal

 PERFORMANCE ORDER

  1. Remove the case of the air filter and an air inlet sleeve.
  2. Remove a V-shaped belt (see the Head of Adjustment and car routine maintenance).
  3. Disconnect pressure head and returnable hydraulic lines from pump GUR, in advance having substituted capacity for gathering of a following liquid. Закупорьте unions and hoses On an accompanying illustration the diesel engine of 1.5 l is shown.

Hydraulic lines ГУР

  1. On petrol engines disconnect the pump from the holder and remove it.

Pump GUR fastening on petrol models

  1. On the diesel engine of 1.5 l remove натяжитель, disconnect the pump and remove it.

On diesel engines for pump GUR removal it is necessary to remove натяжитель приводного a belt

Installation

 PERFORMANCE ORDER

  1. On the diesel engine of 1.5 l tighten fixture of the holder of the pump to a head of cylinders with effort of 60 Nanometers.
  2. Tighten fixture of pump GUR with effort of 30 Nanometers.
  3. Fix a pressure head hose on the pump with effort of 30 Nanometers.
  4. Attach a returnable hose.
  5. Establish a V-shaped belt and pull it (see the Head of Adjustment and car routine maintenance).
  6. Establish the air filter and an air inlet sleeve.
  7. Fill the tank with liquid ГУР.
  8. Start the engine and track liquid level in tank GUR. At level fall at once add a liquid, its level should not fall for the bottom mark.
  9. Remove air from hydraulic path ГУР (see Has undressed Removal of air of hydraulic path ГУР).