Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation



Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of steering draught
      Removal and installation of a tip of steering draught
      Removal and installation of the tank of liquid ГУР
      Removal of air of hydraulic path ГУР
      Removal and pump GUR installation
      Corners of installation of wheels
+ Body
+ Onboard electric equipment


Steering

Removal and steering wheel installation

Removal

Resulted below instructions concern only steering wheels without safety pillows. From safety reasons to remove a safety pillow follows on HUNDRED.


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Establish forward wheels in position of rectilinear movement.
  3. Cautiously a screw-driver uncover with the horn button.

Removal of a cover of a steering wheel from the horn button

  1. Unbend a lock plate of a nut of fastening of a steering wheel and give a nut.
  2. Mark position of a steering wheel concerning a steering shaft.
  3. Remove a steering wheel by means of a stripper, for example, OPEL-КМ-210-А.

Steering wheel removal

For simplification of removal it is not necessary to knock on a steering shaft and to pull a steering wheel every which way.

  1. If necessary replace a cable drum in a steering wheel nave.

The segment of external illumination on a cable drum in position of its installation should be turned on the left.

Segment of external illumination on a cable drum of a steering wheel

  1. Grease a contact surface of a cable drum with greasing Kontaktfix or vaseline oil.

Installation

 PERFORMANCE ORDER

  1. Establish into place a steering wheel so that the labels put in advance have coincided.
  2. Establish a new lock plate and tighten a nut of fastening of a steering wheel with effort of 25 Nanometers.
  3. Be passed on the car, having checked up correctness of installation of a steering wheel.
  4. Fix a nut of fastening of a steering wheel a lock plate.
  5. Remove electroconducting on a cover of a steering wheel and establish a cover.
  6. Connect a negative wire to the battery and check up work of a sound signal.
  7. Check up an automatic reset of the switch of external illumination.

The polluted steering wheel can be washed up a neutral household solution and warm water.