Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
The general information
+ Forward suspension bracket
+ Back suspension bracket
- Steering
Removal and installation of steering draught
Removal and installation of a tip of steering draught
Removal and installation of the tank of liquid ГУР
Removal of air of hydraulic path ГУР
Removal and pump GUR installation
Corners of installation of wheels
+ Body
+ Onboard electric equipment
|
Removal and installation of a tip of steering draught
|
|
In tips of steering draughts it is cut as right, a current and the left carving. |
Removal
|
|
- Mark position of forward wheels in relation to their naves that it was possible then to establish the balanced wheel in its former position. Turn out bolts of fastening of a wheel on the car standing on the earth. Поддомкратьте redock the car, establish it on props and remove forward wheels.
- Give a nut of fastening of a tip of steering bent for to a rotary fist. A tip remove by means of a usual stripper or tool OPEL KM-507.
Removal of a tip of steering draught
- Measure length (1) tips of steering draught and write down the received value.
Length (1) tips of steering draught
|
|
On models without ГУР the length (1) should make 174 6 mm, and on models with ГУР - 163 6 mm. |
- Give a counternut and turn out a tip.
|
|
Installation
|
|
- Screw a tip before reception of the written down value.
- Establish a tip of steering draught on a rotary fist and tighten new самоконтрящуюся a nut (1) with effort of 35 Nanometers.
Nut of a tip of steering draught
- Check up and if necessary adjust convergence of forward wheels.
- Tighten a counternut of a tip with effort of 50 Nanometers.
- Establish forward wheels so that the labels put at removal have coincided. Lower the car and tighten bolts of fastening of wheels with effort of 110 Nanometers.
|
|
|
|