Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
- Power supply systems, release and decrease in toxicity of the fulfilled gases
- The power supply system
Sbrasyvanie pressure in the power supply system of petrol engines
Check of a condition and replacement of fuel lines and them штуцерных connections
Removal of air from a fuel path of the diesel engine
Removal of pollution from the power supply system of the diesel engine
Removal and installation of components of an inlet air path
Replacement and adjustment of a cable of a drive throttle заслонки
Removal and installation of a pedal of an accelerator
Check and replacement of the fuel pump - petrol models
Replacement of the gauge of a stock of fuel
Removal and installation of a fuel tank
Removal and installation of the case of a throttle - petrol models
+ System of injection of fuel of petrol engines
+ System of injection of fuel of the diesel engine
+ Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of a pedal of an accelerator Petrol models
|
|
- In car salon, for the purpose of providing of access to pedal assemblage, release fixture and remove the left (driver's) bottom section of furnish of the panel of devices.
- Liberate a tip of a cable of gas from an accelerator pedal.
- Give three fixing nuts and remove pedal assemblage from a partition of an impellent compartment
Three bolts of fastening of pedal assemblage
- Check up components of pedal assemblage on presence of signs of deterioration and mechanical damages, replace the failed elements. For dismantling of pedal knot, unhook a spring, shift a clamp and remove a pedal, a basic arm, a returnable spring and axial plugs, - before installation grease plugs and an axis of a pedal with universal greasing.
- Establish on an arm of the plug and a returnable spring, having passed through a spring, establish a pedal. Fix a pedal a clamp and pick up to it a spring.
- Establish pedal assemblage on a regular place and tighten fixing nuts with demanded effort.
- Connect to a pedal a gas cable, check up reliability of landing of the plug through passage, then establish into place finishing section of the panel of devices.
- In summary make adjustment of a cable of gas (the Section Replacement and adjustment of a cable of a drive throttle заслонки see).
|
|
Diesel models
|
|
- In car salon, for the purpose of providing of access to pedal assemblage, release fixture and remove the left (driver's) bottom section of furnish of the panel of devices.
- Give fixing nuts and remove pedal assemblage from a partition of an impellent compartment
Three nuts of fastening of pedal assemblage
- Having shifted запорный an element on a socket, disconnect electroconducting from the gauge of position of a pedal of an accelerator.
- At the moment of drawing up of the present Management the pedal knot was made not folding. In case of a pedal exit out of operation the knot is subject to replacement in gathering.
- Establish pedal assemblage and tighten nuts of its fastening with demanded effort.
- Connect electroconducting to the gauge of position of a pedal and establish into place the bottom section of furnish of the panel of devices.
|
|
|
|