Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation

Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
- Power supply systems, release and decrease in toxicity of the fulfilled gases
   - The power supply system
      Sbrasyvanie pressure in the power supply system of petrol engines
      Check of a condition and replacement of fuel lines and them штуцерных connections
      Removal of air from a fuel path of the diesel engine
      Removal of pollution from the power supply system of the diesel engine
      Removal and installation of components of an inlet air path
      Replacement and adjustment of a cable of a drive throttle заслонки
      Removal and installation of a pedal of an accelerator
      Check and replacement of the fuel pump - petrol models
      Replacement of the gauge of a stock of fuel
      Removal and installation of a fuel tank
      Removal and installation of the case of a throttle - petrol models
   + System of injection of fuel of petrol engines
   + System of injection of fuel of the diesel engine
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Sbrasyvanie pressure in the power supply system of petrol engines

Remember that gasoline is extremely an inflammable liquid! At work with power supply system components observe all taken measures of fire safety. Do not smoke! Do not come nearer to a place of work with open fire or the redurable not protected by a lamp shade! Do not make system service in the premises equipped working on natural gas and heating devices equipped with a control torch (such as водогреи and dryers for clothes). Do not forget that gasoline is among cancerogenic substances, i.e., - the substances promoting development of a cancer! Try not to suppose fuel hit on open sites of a body, - use rubber protective gloves, at casual unforeseen contact to fuel carefully wash hands warm water with soap. Immediately collect the spilt fuel and do not put the rags impregnated with PETROLEUM PRODUCTS near to sources of open fire. Remember that the power supply system equipped with injection of fuel of models constantly is under pressure. Before to start a detachment of fuel lines, dump residual pressure in system. At service of components of the power supply system put on goggles. Constantly hold near at hand the class fire extinguisher In!

As already it was mentioned above (the Section of the Power supply system, release and decrease in toxicity of the fulfilled gases see), the power supply system structure includes the electric fuel pump placed in a tank погружного, the fuel filter, injection injectors, a regulator of pressure and the connecting listed components fuel lines. Fuel in a power supply system path at the working engine and the included ignition is under pressure. Residual superfluous pressure continues to be kept in system during even some time after deenergizing of ignition and before a detachment of components/undockings штуцерных sockets should be dumped.

Pressure dump in the power supply system should be carried out before service of any of its components for the purpose of minimisation of risk of ignition of fuel and reception by the executor of traumas.


  1. On engines X12SZ, C14SZ and X14NZ disconnect electroconducting of the relay of the fuel pump (marksman) located in a foot well, behind a cover of right rack A and start the engine on 5 with to dump pressure of fuel.

The relay of the fuel pump

  1. On engines X14SE, X14XE, X16XE, C16XE and engines DOHC of 1.0 and 1.2 l remove a safety lock of the fuel pump (№ 26 in the block of safety locks), start the engine and allow to it to work until it will not decay itself then turn the engine a starter on 2 3 turns.