Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation


Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
- Systems of an electric equipment of the engine
   The general information and safety measures
   - Electronic control system of ignition (and injection) petrol engines
      Checks of serviceability of functioning of system of ignition
      Diagnostics of malfunctions - the general information and preliminary checks
      System of onboard self-diagnostics OBD - the general information
      Application of an oscillograph for supervision of working parametres of a control system
      Check of the coil ignitions (engine C14NZ)
      Removal and installation of the distributor ignitions (engine C14NZ)
      Removal and installation of the block of management by ignition DIS
      Check and the basic adjustment of the moment ignitions (engine C14NZ)
      Oktan-correction
   + Systems of preheat and heating of fuel of the diesel engine
   + Charge and start systems
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the distributor ignitions (engine C14NZ)

The ignition distributor is resulted in rotation from a camshaft and fixed on a head of cylinders from outside a flywheel.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Mark with a felt-tip pen or чертилкой distributor position in relation to a head of cylinders.

Drawing of adjusting labels of the distributor

  1. Uncover the distributor and put aside. For this purpose unbend lock скобы sideways at the distributor from a cover by means of a screw-driver.
  2. Separate a multicontact socket of the case of the distributor for what press wire скобу. Thus pull for the tip, instead of for a cable.
  3. Disconnect a tension lath.
  4. Take out the distributor of ignition with a tension lath from camshaft bed.
  5. Do not turn a cranked shaft at the removed distributor of ignition.

Installation

 PERFORMANCE ORDER

  1. Insert the distributor a shaft pin into a camshaft groove.

The pin and groove are located excentricly and can be combined only in one position.

  1. Fix by hand a tightening lath.
  2. If the rotor has been removed, check up its position, подвигав forward and back.
  3. Turn the distributor so that both labels were combined. Tighten fixture of a tightening lath. If the distributor is replaced, turn it so that inflow on it (on the right about a groove) was opposite to inflow on the camshaft case.
  4. Clear inside a distributor cover, establish, and fix it скобами. Connect an electroconducting socket.
  5. Check up the basic adjustment of the moment of ignition (see the Head of Adjustment and car routine maintenance).