Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation


Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
- Engines
   The general information
   Check компрессионного pressure in cylinders and parametres of impellent oil
   Diagnostics of a condition of the engine with vacuum gauge application
   + Procedures of repair of petrol engines SOHC without their extraction from the car
   - Procedures of repair of petrol engines DOHC without their extraction from the car
      Removal and cover installation газораспределительного the mechanism
      Removal and installation of a belt of drive ГРМ (engines 1.4 and 1.6)
      Removal and installation of cogwheels cranked and camshafts and intermediate rollers (engines 1.4 and 1.6)
      Removal and installation of camshafts
      Removal and installation of a head of cylinders
      Removal and pallet installation картера
      Removal, service and installation of the oil pump
      Replacement of epiploons of camshafts
      Removal, check of a condition and installation of a flywheel/privodnogo of a disk
      Replacement of epiploons of a cranked shaft
      Removal and installation of a pulley of a cranked shaft
   + Procedures of repair of diesel engines without their extraction from the car
   + The general and engine major repairs
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and pallet installation картера

See Has undressed Removal and pallet installation картера.

Pay attention that on models 1.4 and 1.6 l the pallet is established through a lining which at assemblage is subject to replacement without fail. At installation on models 1.4 and 1.6 l hermetic is put on an interfaced surface of the block of cylinders in areas пристыковки cases of the oil pump and a cover of the back radical bearing.