Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation



Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
- Controls and operation receptions
   The panel of devices
   The information display
   Additional electronic devices
   Access, protection
   Salon illumination
   Elements of systems of safety of the car
   The salon equipment
   Comfort
   Operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Comfort

Systems of heating, ventilation and air conditioning

At correct use of possibilities of systems of heating and ventilation in car salon comfortable conditions of stay are provided and is excluded запотевание glasses.

If the car at purchase has not been equipped by air central air (К/В), it can be mounted and established during any time convenient for the owner, - address on HUNDRED Opel.

The control panel functioning of systems of ventilation and salon heating

The general view of the control panel with instructions of an arrangement of handles is presented At the left the handle of a regulator of temperature of air and inclusion К/В (is located at a corresponding complete set). At a complete set of the car system K/V on this handle puts the pictogramme in the form of a snowflake. In the centre the handle of a choice of a high-speed mode of the fan and heating of back glass is located. On the right there is a handle of switching of directions of giving of air. From below the switch of a mode of air circulation is located.

The control panel functioning of systems of heating, ventilation and К/В

The handle of a regulator of temperature of air and inclusion К/В

Handle rotation clockwise leads to increase in temperature of the car of air arriving in salon. At вытягивании handles joins К/В, and the control lamp built in the handle lights up.

The handle of a choice of a high-speed mode of the fan and heating of back glass

Handle rotation clockwise leads to increase in speed of rotation of the fan and, hence, - intensity of giving of air in car salon. Handle transfer in extreme left position leads to fan switching-off. At вытягивании handles the heating of the back glass accompanied by operation of a control lamp built in the handle joins.

Switch off heating of back glass as soon as visibility through it will be restored.

The switch of a mode of air circulation

At extreme right position of the given lever inclusion of a mode of air circulation in car salon is made. At inclusion of a mode the car salon is isolated from atmosphere and inflow to it of fresh air stops. The fan provides air circulation in salon. At deenergizing of a mode of circulation (the lever is in extreme left position) giving of external air in salon will renew.

The handle of switching of directions of distribution of air

At air giving on obverse level do not forget to open дефлекторы.

The handle is intended for a choice of a mode of distribution of air in salon.

Air giving through lateral дефлекторы panels of devices is carried out in all modes.

Components of system of heating and salon ventilation

1 — the Air filter
2 — the Case of the air filter
3 — the Case ventilating заслонки
4 — the Case central дефлектора
5 — the Panel of the block of management of a heater
6 — the Right air line
7 — Right дефлектор
8 — the Lattice дефлектора
9 — the Handle of a regulator of temperature of air
10 — the Handle of switching of directions of giving of air

11 — the Handle of a choice of a high-speed mode of the fan and heating of back glass
12 — the Switch of a mode of air circulation
13 — the Switch of heating of a forward seat
14 — the Air line обдува wind втекла
15 — the Block of management of a heater
16 — the Case воздухораспределителя
17 — the Heating element
18 — the Support of a heating element
19 — the Case воздухораспределителя
20 — Left дефлектор
21 — the Left air line


External air arrives on having blown in a windscreen through the nozzles which have been built in in the control panel from above near to the bottom edge of glass.
External air arrives in salon simultaneously through nozzles обдува a windscreen, built in in the control panel from above near to the bottom edge of glass, and through the bottom ventilating apertures of foot wells.
Giving of external air only in driver's and passenger foot wells is carried out.
External air arrives in salon on obverse level through central and lateral ventilating дефлекторы panels of devices.

Management дефлекторами ventilating lattices

Дефлекторы snuffled the central air lines of the panel of devices are equipped special жалюзийными дефлекторами, allowing to regulate a deviation of a submitted air stream both in horizontal, and in vertical planes. Management дефлекторами is carried out by means of the ring handles located on the parties (0 - air giving is blocked) and built in a lattice snuffled рычажков.

Adjustment of a deviation of the air stream submitted to salon through the central air lines of the panel of devices

Дефлекторы snuffled lateral air lines of the panel of devices have a similar design, besides (1), hardly noncontrollable nozzles обдува door glasses (2) are above located.

Adjustment of a deviation of the air stream submitted to salon through lateral air lines of the panel of devices

1 — Deflektor of an air line of giving of air on obverse level
2 — the Nozzle обдува door glass

Instructions on use of systems of ventilation, heating and air conditioning

Detailed maintenance instructions of systems of heating, ventilation and К/В in various environmental conditions are more low resulted. The information on is presented attention of the reader how to provide effective ventilation, heating and air cooling in car salon, and also how quickly to remove from glasses a condensate and hoarfrost.

All considered systems function only at the started engine. As a working body of the heat exchanger of a heater the cooling liquid of the engine is used. If the engine is not heated-up to normal working temperature, some minutes before in salon warm air will start to move is required.

Functioning of a central air of air does not depend on temperature of a cooling liquid of the engine.

In overwhelming majority of cases the best efficiency of functioning of the systems providing a comfortable microclimate, is reached in a giving mode in salon of external air. Long inclusion of a mode of circulation, especially at idle К/В, leads запотеванию glasses and to increase спертости air, therefore it is recommended to include the given mode only in case of need and for rather short time, for example, at movement on district with the filled with smoke or polluted atmosphere. As soon as necessity of isolation of salon will disappear, giving in salon of fresh air should be renewed.

External atmospheric air arrives in systems of heating and К/В through the receptions a lattice located before a windscreen and equipped обтекателем. Periodically clean apertures of a reception lattice from leaves and the other dust complicating passage of air.

Ventilation of salon of the car

 PERFORMANCE ORDER

The forced-air and exhaust ventilation system provides a constant exchange of air in car salon. Fresh external air through a forward reception lattice arrives in salon and then leaves through the exhaust outlets located in ware boxes of a luggage space.
  1. Turn the handle of a regulator of temperature of air counter-clockwise against the stop. Check up, that К/В has been switched off;
  2. Establish the handle of switching of directions of giving of air in position. The air circulation mode should be switched off;
  3. By means of the handle of a choice of a high-speed mode of the fan establish demanded intensity of giving of air in car salon.

Air cooling in car salon

The choice of a mode of cooling is possible only at the working engine. At temperature of external air more low +4 hailstones. There is an automatic switching-off of a mode of cooling.


 PERFORMANCE ORDER

Salon cooling is made as follows:
  1. Include air conditioner, - should light up built in switch K/V;
  2. Check up, that the handle of a regulator of temperature of air has been turned in extreme left position;
  3. Establish the handle of switching of directions of giving of air in position;
  4. At high humidity of external air include a circulation mode, at low humidity, - a mode of inflow of fresh air;
  5. By means of the handle of a choice of a high-speed mode of the fan establish demanded intensity of giving of air in salon.

 PERFORMANCE ORDER

If the car has staid long time for the sun and air in salon has strongly heated up, quickly to lower temperature in salon it is possible as follows:
  1. Start the engine;
  2. Include air conditioner. Check up, that the handle of a regulator of temperature of air has been turned in extreme left position;
  3. By means of the handle of a choice of a high-speed mode of the fan establish the maximum intensity of giving of air in salon;
  4. Partially slightly open windows and turn the handle of switching of directions of distribution of air in position;
  5. Include a circulation mode, after a while close windows.

System K/V work leads to loading increase on the car engine, therefore, moving with frequent stops and on small speed in the conditions of an intense city cycle, or overcoming long liftings of a considerable steepness, it is necessary to watch closely an arrow of the index of temperature of a cooling liquid (see Has undressed the Panel of devices). At approach of an arrow of the index to a red range of a scale, temporarily switch off air conditioner until the engine temperature will not return to norm.

Heating of salon of the car

 PERFORMANCE ORDER

To lift air temperature in car salon, execute following manipulations.
  1. Start the engine;
  2. Establish the handle of switching of directions of distribution of air in position. The air circulation mode should be switched off;
  3. By means of the handle of a choice of a high-speed mode of the fan establish demanded intensity of giving of air in salon;
  4. Turning the handle of a regulator of temperature of air, establish desirable degree of heating of air.

Heating of salon with simultaneous drainage of air by means of the conditioner

 PERFORMANCE ORDER

At work of a central air humidity of air in car salon decreases that allows by simultaneous inclusion of systems of heating and air-conditioning to make air in car salon warm and dry.
  1. Include the fan;
  2. Include air conditioner;
  3. Establish the handle of switching of directions of distribution of air in position or. The air circulation mode should be switched off.
  4. Turning the handle of a regulator of temperature of air in this or that party, establish desirable degree of heating of air arriving in salon. In the given mode cold air from the conditioner mixes up with warm air from a heater.

Joint inclusion of systems of heating and air conditioning can be applied in any traffic conditions, when temperature of air the positive.

Removal from condensate and hoarfrost glasses

 PERFORMANCE ORDER

To clear internal surfaces of glasses of the condensed moisture it is possible as follows:
  1. Include the fan;
  2. At a corresponding complete set of the car include air conditioner;
  3. Establish the handle of switching of directions of distribution of air in position. The air circulation mode should be switched off;
  4. Turn the handle of a regulator of temperature of air in such position that warm air moved through nozzles обдува a windscreen;
  5. Include an electroheater of back glass for faster removal of the condensed moisture from its surface. On some variants of execution of the car if the handle of switching of directions of distribution of air is in any position, except, К/В remains included. If necessary switch off the conditioner.

 PERFORMANCE ORDER

To remove from an external surface wind and lateral glasses hoarfrost or the ice formed after parking of the car in the street in frosty weather, execute following manipulations:
  1. Include ignition, having turned a key in the lock in position ĞIIğ;
  2. Establish the handle of switching of directions of distribution of air in position. The air circulation mode should be switched off;
  3. Turn the handle of a regulator of temperature of air in extreme right position (the maximum heating of air) and include the fan for the maximum speed;
  4. Start the car engine.

For acceleration of clearing of a windscreen from hoarfrost or ice it is recommended to include an air circulation mode in very cold weather at first. After the windscreen will be released from наледи, renew giving of fresh air for the purpose of prevention запотевания glasses.

In a mode обдува glasses all submitted to air salon arrives through the slot-hole nozzles located from above on the panel of devices at the basis of a windscreen, and also through lateral ventilating дефлекторы panels of devices. The temperature of air blowing in glasses, and speed of clearing of glasses increase in process of engine warming up. For acceleration of process of removal from a windscreen of a condensate, hoarfrost or ice it is possible to close lateral ventilating дефлекторы. In this case all air will go exclusively on having blown in a windscreen.

From safety reasons it is not necessary to begin movement until all windows of the car will not be cleared of a condensate, and to the driver the adequate review will not be provided.

Deenergizing of systems of heating and ventilation

Temporarily to disconnect heating and ventilation systems, turn handles of regulators of a high-speed mode of the fan and air temperature in their extreme left positions.

Necessity for switching-off of systems arises in the first some minutes after engine start in cold weather as it provides faster warming up of the engine to temperature, sufficient for effective functioning of a heater. In all other cases, in order to avoid air stagnation in salon, hold the fan constantly included.