Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation


Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
- Controls and operation receptions
   The panel of devices
   The information display
   Additional electronic devices
   Access, protection
   Salon illumination
   Elements of systems of safety of the car
   The salon equipment
   Comfort
   Operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

The information display

On the display screen at the included ignition indication of values of time and temperature of external air, date or the data of the chosen radio station, and also the information of automobile phone (is deduced at a corresponding complete set).

The three-functional information display of the models which have been not completed with automobile phone
The three-functional information display of the models completed with automobile phone

Brightness of the screen on models without automobile phone is regulated by means of the same potentiometer by which intensity of illumination of devices is regulated; brightness of the screen on models with automobile phone is not regulated.

At the switched off ignition the current information (time, date, temperature of external air) can be displayed for 15 seconds of the display by short-term pressing one of two operating buttons close to the screen.

After failure in an onboard network of a food of the car written down earlier given are erased. After restoration of a food the display on two minutes is automatically switched in a mode of installation of date and time. In the presence of time signal on RDS the display of the models equipped with automobile phone, automatically will establish date and time. Otherwise establish date and time it is independent.

Indication of temperature of external air

The thermometer reacts to fall of temperature of air at once, and on increase – with some delay. Be cautious: when the thermometer shows some degrees above zero, on road there can be a glaze ice.

For the prevention of risk of an icing of road at decrease in temperature of external air to value nearby 3 hailstones indication blinks within approximately 20 seconds.

Signal of failure in system work is the conclusion to the screen of the display of an inscription – . - С, or symbol F - drive away the car on car repair shop Opel.

Date and time installation

Manual installation

Include a radio receiver. Installation is made by means of two buttons and, located to the right of the display:

  1. Within nearby 2 seconds keep pressed the button, - the indication of day of week should start to blink;
  2. By means of the button make installation of day of week;
  3. By means of the button pass to installation of the indication of month;
  4. The button modify the indication;
  5. Pass to installation of the indication of year;
  6. Modify the indication;
  7. Pass to installation of the indication of hours;
  8. Modify the indication;
  9. Pass to installation of the indication of minutes;
  10. Modify the indication;
  11. Start of hours (with zeroing of readout of second indications).

If necessary to establish only correct current time, keep the button until the indication of hours or minutes will start to blink.

Automatic installation

On the models equipped with automobile phone, current time and date can automatically be established at receipt on a radio receiver of a signal of system of the radio data (RDS).

The input in a mode of automatic installation of time on signal RDS is made as follows:

  1. Within nearby 2 seconds keep pressed the button, - hours should pass in an adjustment mode.
  2. Twice press the button, - the indication of year should start to blink;
  3. Keep the button pressed during nearby 3 seconds until on the display screen the pictogramme will not be highlighted in a flashing mode and there will be no inscription RDS TIME (the indication of year should continue to blink);
  4. Button pressing make inclusion or deenergizing of a mode of automatic installation of time: RDS TIME 0 - off; RDS TIME 1 - incl.;
  5. For an exit from an installation mode press the button three times.