Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
The general information
+ Forward suspension bracket
- Back suspension bracket
Removal and installation of a spring of a back suspension bracket (model Corsa and Tigra)
Removal and installation of the stabilizer of cross-section stability (model Corsa and Tigra)
Removal and installation of the bearing of a wheel
Backlash adjustment in the wheel bearing
+ Steering
+ Body
+ Onboard electric equipment
|
Backlash adjustment in the wheel bearing
|
|
- Поддомкратьте a car back so that to release a corresponding wheel.
- Accurately uncover wheels a screw-driver.
- Extend шплинт корончатой nuts.
- For bearing landing tighten корончатую a nut with effort of 25 Nanometers.
|
|
Turn a brake drum at a nut tightening not to jam the bearing. |
Tightening ступичной nuts
- Some times move a nave every which way that the bearing has taken a correct place.
- Release slowly ступичную a nut so that the press washer могласлегка to move.
Moving of a press washer
- At отпускании nuts check up a backlash in the wheel bearing. The backlash is adjusted truly if the press washer can be moved slightly only a screw-driver.
|
|
Thus the screw-driver at moving should not lean against a nave. |
- At installation шплинта tighten a nut to the nearest aperture under шплинт.
- Check up, whether the press washer can be displaced. If is not present, release a nut to the nearest aperture under a pin.
- Insert new шплинт into an aperture and unbend its ends.
- Fill a nave cover литиевой with greasing and then cautiously establish it with a new sealing ring.
|
|
It is necessary to replace the deformed cover, since owing to it негерметичности the moisture can get into the wheel bearing and it can collapse. |
- Lower the car on the earth.
|
|
|
|