Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
The general information
+ Forward suspension bracket
- Back suspension bracket
Removal and installation of a spring of a back suspension bracket (model Corsa and Tigra)
Removal and installation of the stabilizer of cross-section stability (model Corsa and Tigra)
Removal and installation of the bearing of a wheel
Backlash adjustment in the wheel bearing
+ Steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the stabilizer of cross-section stability (model Corsa and Tigra) Removal
|
|
- Mark position of a back wheel concerning its nave that then the balanced wheel it was possible to establish in former position. Ослабьте bolts of fastening of a wheel on the car standing on the earth. Поддомкратьте a car back, establish it on props and remove a wheel.
- Disconnect the stabilizer from a back axis.
- Remove rubber демпфирующую a stabilizer support.
- Remove the stabilizer from assemblage of a back suspension bracket If the stabilizer does not act in film, remove an opposite back wheel and beat out the stabilizer выколоткой.
Stabilizer removal
- Check up a condition rubber демпфирующей support and if necessary replace it.
|
|
Installation
|
|
- For simplification of installation grease the stabilizer of cross-section stability with greasing.
- Establish the stabilizer on a back suspension bracket.
- Insert rubber демпфирующую a support into a back axis and check up reliability of its installation.
- Tighten new bolts of fastening of the stabilizer with effort of 60 Nanometers, and then tighten them on 15 hailstones.
Tightening of bolts of fastening of the stabilizer
- Establish a back wheel so that have coincided put before a label. Lower the car on the earth and tighten bolts of fastening of wheels cross-wise with effort of 110 Nanometers.
|
|
|
|