Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation


Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information
   - Forward suspension bracket
      Dismantling, check and assemblage of an amortisation rack
      Removal and installation of the cross-section lever of a suspension bracket
      Removal and installation of the stabilizer of cross-section stability
   + Back suspension bracket
   + Steering
+ Body
+ Onboard electric equipment

Removal and installation of the stabilizer of cross-section stability

Removal

 PERFORMANCE ORDER

  1. Give coupling nuts (1) collars from the right and left parties of draught and remove the stabilizer.

Coupling nuts of collars of fastening of the stabilizer

Installation

 PERFORMANCE ORDER

  1. Grease a rubber support with silicone oil (OPEL № 90 001 800 or 19 48 454). The damaged rubber support replace.
  2. Fix the stabilizer in area лысок collars to the left and right draughts and tighten new самоконтрящиеся nuts with effort of 20 Nanometers. Observe thus the size And between an internal bolt of draught and the centre of a rubber support.

The size of installation of a collar
A — 121 mm

Features of engines DOHC of 1.0 and 1.2 l

 PERFORMANCE ORDER

  1. Watch correct position of the stabilizer: the right pin in installation position should be turned downwards the Size A, designated on an illustration, for engines DOHC of 1.0 and 1.2 l should make 110 mm.

Stabilizer orientation at installation