Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation


Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information
   - Forward suspension bracket
      Dismantling, check and assemblage of an amortisation rack
      Removal and installation of the cross-section lever of a suspension bracket
      Removal and installation of the stabilizer of cross-section stability
   + Back suspension bracket
   + Steering
+ Body
+ Onboard electric equipment

Removal and installation of the cross-section lever of a suspension bracket

Removal

 PERFORMANCE ORDER

  1. Поддомкратьте the car also establish it on props. Give a fixing nut (1) and disconnect the lever from a body.

Nuts of fastening of the cross-section lever to a body (1) and a spherical support

  1. Disconnect from the lever draught and a spherical support and remove the lever.

On HUNDRED it is possible выпрессовать a rubber support of the lever of a suspension bracket and to replace it with the new.

Installation

 PERFORMANCE ORDER

  1. Insert the suspension bracket lever between a spherical support and draught and fix new bolts with a fillet and new самоконтрящимися nuts. Nuts follows наворачивать from below and to tighten in two steps: at first - with effort of 90 Nanometers and then to tighten on a corner 30 45 hailstones.
  2. Insert behind a bolt of fastening of the lever to a body and screw new самоконтрящуюся a nut, without tightening it.
  3. Lift the lever by means of a jack so that it has occupied almost horizontal position, a corner a makes about 80 hailstones.

Corner of installation of the lever (80 hailstones.)

  1. In this position tighten a nut with effort of 60 Nanometers. Clean a jack and lower the car on the earth.