- Remove a casing of the fan of a heater, the fan e/motor leave in a casing.
- From salon separate a socket located to the right of a steering shaft, from a fan casing (the additional resistor).
Arrangement of a socket of electroconducting
- Turn out the screw of fastening (1) additional resistors from an impellent compartment.
The screw of fastening (1) and sockets (2) additional resistors
- Separate two sockets (2). Pay attention to various width of plugs: the plug of a brown cable has width of 7.7 mm, and plugs of black and red cables - width of 6.3 mm
- Installation is made upside-down.
|