Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation


Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
- Systems of cooling of the engine, salon and air conditioning heating
   The general information and safety measures
   Antifreeze - the general data
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of the switch of high-speed modes of the fan
      Removal and installation дефлекторов air lines
      Removal and installation of the block of management by heating
      Removal and installation of draughts of a drive заслонок a heater
      Removal and installation of the fan of a heater
      Removal and installation of the additional resistor
      Check of serviceability of functioning and service of systems of heating and air conditioning
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the block of management by heating

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove both central дефлектора.
  3. Remove the handle of the switch of modes of the fan.
  4. Remove the switch of the anticreeping alarm system.
  5. At a corresponding complete set take out a suitable hook the switch of heating of a forward seat.
  6. Remove the handle of the switch of a mode of ventilation of air.

Removal of the handle of the switch of modes of ventilation

  1. Remove an overlay of the switch of a mode of ventilation of air.

Removal of an overlay of the switch of modes of ventilation

  1. Turn out screws of fastening (1) and take out the panel of the block of management.

Screws of fastening of the panel of the block of management of a heater

  1. Disconnect cables (1, 2, 4, 5) from the block of management and separate an electroconducting socket. Extend a socket (3).

Cables (1, 2, 4, 5) and a socket (3) blocks of management

№  Draught for заслонки
1    Foot wells
2    Ventilation and having blown in a windscreen
4    Air line
5    Ventilation

    Colour
   The grey
   The brown
    The black
    Dark blue

  1. Turn out screws of fastening (2). Disconnect from the panel the block of management and the case дефлекторов, having wrung out clamps (1).

Screws of fastening (2) and clamps (1) blocks of management

  1. Installation is made upside-down. Draughts заслонок establish in conformity with an illustration.