Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation


Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
- Systems of cooling of the engine, salon and air conditioning heating
   The general information and safety measures
   Antifreeze - the general data
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of the switch of high-speed modes of the fan
      Removal and installation дефлекторов air lines
      Removal and installation of the block of management by heating
      Removal and installation of draughts of a drive заслонок a heater
      Removal and installation of the fan of a heater
      Removal and installation of the additional resistor
      Check of serviceability of functioning and service of systems of heating and air conditioning
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of draughts of a drive заслонок a heater

Removal

 PERFORMANCE ORDER

Remove the block of management of a heater and disconnect corresponding draught (see Has undressed Removal and installation of the block of management by heating).

Draught of a drive заслонки ventilation and обдува a windscreen

 PERFORMANCE ORDER

  1. Remove a pocket under the right part of the panel of devices.
  2. Disconnect draught from a support (1) and the lever (2). Take out draught from directing (3) on the case воздухораспределителя below on the right.

Support (1) and the lever (2) draughts

Draught of a drive заслонки foot wells

 PERFORMANCE ORDER

Disconnect draught (1) from the case воздухораспределителя below on the right and disconnect it from the lever (2). Take out draught.

Draught (1) and the lever воздухораспределителя (2)

Draughts of a drive заслонки air lines (temperature regulation)

 PERFORMANCE ORDER

  1. Remove a pocket under the right part of the panel of devices.
  2. Disconnect draught (2) to the right of the case of the e/motor of the fan and disconnect an internal cable Disconnect and take out draught at the left from the holder (1).

The holder (1) and draught (2)

  1. Installation is made upside-down. Draughts establish in conformity with an illustration.

Cables (1, 2, 4, 5) and a socket (3) blocks of management

№  Draught for заслонки
1    Foot wells
2    Ventilation and having blown in a windscreen
4    Air line
5    Ventilation

    Colour
   The grey
   The brown
    The black
    Dark blue


At a lining of draughts do not bend in their radius less than 60 mm.