Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
- Systems of cooling of the engine, salon and air conditioning heating
The general information and safety measures
Antifreeze - the general data
- System of cooling of the engine
Service of system of cooling (опорожнение, washing and refuelling)
Removal, installation and check of serviceability of functioning of the thermostat
Removal and installation of a radiator of system of cooling
Check of serviceability of functioning, removal and installation of the fan of system of cooling
Check of serviceability of functioning of the gauge of temperature of a cooling liquid (ECT)
Check of a condition of the water pump
Removal and installation of the water pump
+ Systems of ventilation, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
System of cooling of the engine Detachment and replacement of hoses of system of cooling
If during performance of the checks listed in corresponding Section of the Head of Options and routine maintenance of the car, defects of hoses of system of cooling are revealed, they should be replaced.
|
|
- Empty cooling system (see the Head of Adjustment and car routine maintenance). If the cooling liquid filled in system is enough fresh, it is subject to a reuse and should be merged in pure container.
- Try to remember a route of a lining of a hose subject to replacement. For a hose detachment ослабьте collars of its fastening on unions/branch pipes of corresponding components. Shift collars on a hose, completely having released посаженые on unions sites of the last. Cautiously remove a hose from the unions/branch pipes.
- Remember that inlet and final branch pipes of a radiator are fragile enough elements - do not make excessive efforts at снимании from them hoses. For simplification of removal повращайте a hose on the union. As a last resort, strongly "become attached" hose can be cut off from the union a knife - despite connected with in such a way certain material inputs, nevertheless will replace more cheaply a hose, than to get a new radiator.
- At installation of a new hose at first put on it fixing collars, only after that pull a hose on unions/branch pipes of corresponding components охладительного a path. If it is primary for fastening of hoses collars of braided type have been used, they should be cut off and at installation to replace more reliable screw or worm. For simplification of landing of rigid hoses on unions it is necessary to moisten slightly the ends of the last with soap water, or to warm up in warm water the hose ends - do not use as greasing any oils.
- Pull a hose the ends on unions and check up correctness of its lining in an impellent compartment. Place collars on the sites of a hose planted on unions, having got them for развальцовку unions/branch pipes. Tighten coupling screws.
- Fill cooling system (see the Head of Adjustment and car routine maintenance).
- Start the engine, then attentively check up system on presence of signs of leaks of a cooling liquid.
|
|
|
|