Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation

Check of serviceability of functioning, removal and installation of the fan of system of cooling

At the hot engine the fan of system of cooling can be activated at any moment, - observe extreme care!

Check

The electric fan receives a food from the storage battery. The structure of an electric contour of the fan includes a protective safety lock, the switch of ignition and the relay (the Onboard electric equipment see the Head). The control of functioning of the fan carries out the electronic block of management leaning against the data, temperatures of a cooling liquid arriving from the gauge.

PERFORMANCE ORDER

For check of serviceability of functioning of the fan start the engine and warm up it on single turns to normal working temperature. The fan should work before the arrow of the index of temperature of the engine on the panel of devices of the car will come nearer to overheat sector on a dial. If fan operation does not occur, check up serviceability of giving of pressure of a food on a corresponding wire of the fan and the relay (the Onboard electric equipment see the Head). Refusal of giving of a food can result выбивания from a safety lock, failure of the switch of ignition, malfunction of the relay or electroconducting damage. The probability of failure приводного the fan electromotor is not excluded also.

Removal

PERFORMANCE ORDER

Disconnect a negative wire from the battery. On the diesel engine without pressurisation remove an air inlet sleeve. On a turbodiesel remove directing tube щупа measurements of level of oil from a head of cylinders. At a corresponding complete set remove the tank of liquid ГУР, and take him aside together with hoses. Separate a multicontact socket of the e/motor of the fan. Turn out bolts of fastening of a cover of the fan with the e/motor, extend from the left arm and take out it together with the e/motor upwards. Bolts of fastening of a cover of the fan On the diesel engine arms are at the left and on the right. Remove a screw-driver from a shaft of the e/motor a clip and remove крыльчатку. Clip removal Turn out bolts of fastening and remove the e/motor from the fan case. Bolts of fastening of the e/motor of the fan

Installation

PERFORMANCE ORDER

Installation is made in an order, the return to an order of dismantle of components. Tighten fixture with demanded effort. At installation крыльчатки watch that the pin on an e/motor shaft has entered into a groove крыльчатки. Installation крыльчатки Start the engine and allow to it to get warm so that the fan electric motor has joined.