Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
- Coupling and power shafts
The general information
- Coupling
Removal and coupling installation
Removal, check and installation of the bearing of deenergizing of coupling
Replacement of a cable of a drive of coupling
Check of a condition of components of coupling
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement of a cable of a drive of coupling
|
|
From 09.1995 of release constructive changes of a cable of a drive of the coupling, directing a cable on a pedal and демпфирующего an element at коромысла couplings are made. |
|
|
- If by pressing a pedal of coupling from under the panel of devices noise the reason, as a rule, is the lack of greasing of a cable of a drive of coupling are audible.
- Thus wring out a coupling pedal upwards and grease a hook of a cable of a drive, and also a groove of a pedal of coupling in a place of fastening of a cable with greasing OPEL ET - № 90001825.
- Measure by a ruler length of a carving of the lever of deenergizing of coupling to the adjusting screw and write down the received value to facilitate adjustment of a new cable of a drive of coupling.
Measurement of length of a carving of the lever of deenergizing of coupling
- Remove a screw-driver at a carving element of a cable of coupling lock скобу.
Lock скоба
- Wring out mount the lever of deenergizing of coupling and disconnect a cable. Squeeze out a cable from the holder.
- Disconnect from a coupling pedal a returnable spring and a coupling cable.
Removal of a returnable spring and cable of coupling from a pedal
- Extend a cable from outside an impellent compartment from its partition.
- Installation is made upside-down. Be convinced that the cable correctly lies in the directing.
- Adjust a coupling cable.
- Connect a cable to the holder.
|
|
|
|