Opel Corsa B, Combo, Tigra

Since 1993-2000 of release

Repair and car operation

Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
- Power supply systems, release and decrease in toxicity of the fulfilled gases
   + The power supply system
   + System of injection of fuel of petrol engines
   - System of injection of fuel of the diesel engine
      Check and adjustment of the maximum turns of the engine
      Check and adjustment of installations of the moments of injection of fuel
      Check of a thermosensitive element
      Removal and installation of atomizers
      Heating element of the fuel filter
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
+ Automatic 4-step transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of atomizers

The damaged atomizers can lead to strong detonations at work of the engine and be at the bottom of destruction of bearings. At damage of bearings start the engine on single turns and by turns give накидные nuts топливопроводов on atomizers. If at отдавании any накидной detonation nuts stop, it specifies in defect corresponding an atomizer.

The damaged atomizer can be defined also by consecutive отдавания накидных nuts топливопроводов on atomizers in an engine operating time on the raised single turns. If after отдавания any накидной nuts the number of turns does not change, it specifies in defect of a corresponding atomizer. To define the damaged atomizer it is possible also by means of a manometre at servicing deport.

Signs of damage of an atomizer are:

  • Absence of ignition;
  • Detonations in one or several cylinders;
  • Engine overheat;
  • Decrease in capacity of the engine;
  • Excessively black exhaust;
  • The raised expense of fuel.



  1. Remove the air filter.
  2. Turn out bolts of fastening and remove a final collector.
  3. Clear топливопроводы.
  4. Give накидные nuts топливопроводов and remove them in the complete set.

Nuts of fastening of pipelines

Do not change the form топливопроводов.

  1. Disconnect lines of return of fuel.
  2. Turn out the holder of an atomizer together with an atomizer at the help of special tool OPEL KM-728.
  3. Remove a sealing ring and a figured washer.

Sealing ring of an atomizer



  1. Lay in an aperture for an atomizer in a head of cylinders a new sealing ring and a new figured washer.

The convex part of a washer should look upwards.

  1. Insert an atomizer into an aperture so that the label (1) on an atomizer coincided with a label (2) on a head of cylinders.

Adjusting labels

  1. Tighten накидную a nut special tool OPEL KM-728. Thus the holder of an atomizer keep from проворачивания a wrench.

Tightening накидной atomizer nuts

The atomizer thus should not be turned, and labels should coincide.

  1. Establish lines of return of fuel with a new lining and tighten a nut with effort of 30 Nanometers.
  2. Establish топливопроводы on atomizers and ТНВД and tighten накидные nuts with effort of 25 Nanometers.
  3. Establish the inlet pipeline with a new lining and tighten bolts of fastening with effort of 25 Nanometers.