Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
- Automatic 4-step transmission
The general information
Adjustment of the mechanism of a choice of transfers
Removal and installation of a cable of a choice of transfers
Removal and installation of assemblage of the lever of selector AT
Removal and installation АТ
Major repairs АТ - the general information
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of assemblage of the lever of selector AT Removal
|
|
- Remove the central console (the Body see the Head), then translate the selector lever in position P.
- Disconnect electroconducting from switches of modes and liberate a cartridge of a lamp from the display panel.
- Accurately having hooked a screw-driver, separate a tip of a cable from the lever hinge. Shift a clamp and liberate a cable from a basic arm in front of the lever.
- Turn out four fixing screws and remove lever assemblage.
- Check up knot on presence of signs of deterioration and damages. Give a nut, remove a washer and take axis knot. Release clamps of fastening of the display panel, separate lever knot with a basic arm. Fuller dismantling of knot is not represented possible.
|
|
Installation
|
|
- In case of need establish on lever assemblage a basic arm. Insert an axis. Establish a washer and tighten a fixing nut with demanded effort. Strengthen the display panel on a basic arm. Before lever installation on the car check up serviceability of functioning of assemblage.
- Establish lever knot on the regular place, connect a selector cable. Screw fixing bolts and tighten them with demanded effort.
- Fix a cable of the selector a clamp and connect a cable tip to the lever hinge.
- Having tracked correctness of a lining of a plait, lay electroconducting, establish a cartridge пампы on the display panel and restore initial connection of electroconducting.
- Adjust a cable valley (the Section Adjustment of the mechanism of a choice of transfers see), then establish into place the central console (the Body see the Head).
|
|
|
|