Opel Corsa B, Combo, Tigra
+ Cars Opel Corsa B, Tigra and Combo
+ Controls and operation receptions
+ Options and car routine maintenance
+ Engines
+ Systems of cooling of the engine, salon and air conditioning heating
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual 5-step box of a gear change
- Automatic 4-step transmission
The general information
Adjustment of the mechanism of a choice of transfers
Removal and installation of a cable of a choice of transfers
Removal and installation of assemblage of the lever of selector AT
Removal and installation АТ
Major repairs АТ - the general information
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of a cable of a choice of transfers Removal
|
|
- Remove the central console (the Body see the Head). Translate the selector lever in position Р.
- Screw-driver with a flat sting release a clamp and accurately liberate a tip of a cable from a basic arm, then disconnect a cable from a fixing plate in a forward part of the executive lever.
Release a clamp (1) and remove a tip of a cable (2) from the executive lever (3)
- Remove the storage battery with the adjusting pallet (see the Head of System of an electric equipment of the engine).
- At a corresponding complete set release a clamp and accurately separate a tip of a cable from selector AT lever. Liberate a cover of a cable from a basic arm.
- Walk on all length of a cable from transmission and liberate it from all provided intermediate clamps, do not take the rubber plug through passage from a partition of an impellent compartment.
- Check up a cable condition, - the cable should move freely in a cover.
|
|
|
|
The cable removed from the car can look and function quite regularly, however to begin заедать at bending. In case of need replace a cable. |
Installation
|
|
- Get a cable on the regular place, having passed it in the plug through passage in a partition of an impellent compartment. Fix a cable in a lever plate.
|
|
For simplification of dragging of a cable through the plug through passage preliminary grease with its soap solution. |
- Pass the end of a cable moved to transmission in a basic arm and fix a cover a clamp. Connect a cable tip to the lever and (at a corresponding complete set) fix its clamp.
- In car salon fix a cover of a cable a clamp and connect a tip to the hinge of the lever of the selector.
- Adjust a cable valley (the Section Adjustment of the mechanism of a choice of transfers see).
- Establish the central console and other acting in film components.
|
|
|
|